Garage Door is Not Going Down? Know the Reasons and Solutions

When your garage door or garage door opener cannot function properly or stops operating, you may need to face several unwanted issues. Some causes of this issue are usually quite simple to understand, and even the solution can be pretty simple. However, before that, you must know about the actual problem and contact professionals who have experience in garage door repair in Las Vegas to get the best services possible.

So, in this article, let us discuss some common reasons why your garage door is not working properly and also their solutions.

What is the common issue of the garage door not going down?

One of the most common issues homeowners usually encounter with their garage doors is the door being stuck in the open position. In that situation, the first thing you must check is the photo eye sensors of your garage located on either side of the door.

The sensors that may keep your garage door from closing down can be blocked, and this blockage might be caused by the way things are stacked in your garage. Sometimes it can be the objects that are being kept in storage or a vehicle that is parked too close to the entrance of your garage.

Is it possible to force the garage door down?

If your garage door is difficult to hold or even doesn’t reverse, you must Decrease the Down (close) force just by turning the control in the counter clock way. Also, remember to make small adjustments until your garage door reverses in the normal way. Moreover, after each adjustment, you should run the opener through a complete cycle.

A garage door is not going down: Know some of its reasons and solutions

There are several reasons behind your garage door is not going down or stuck. Here are a few of those reasons, along with their solutions.

1. Check the external controls

When your garage door openers are plugged in, but the door cannot go down, there may be an issue with the external control, such as the keypad, wall switch, or even remote control. So, in that case, you must follow some steps:

• Test all the controls to find out if only one of them is faulty and if others are working.
• If your garage door opener motor has an antenna, then ensure that it is not damaged and is in the right position.
• Then, check the batteries of the garage door opener remote. 
• Now, you can reset or reprogram the keypad or remote control by consulting with your owner’s manual.

2. Check the springs and cables

The torsion springs and cables of your garage door are vital components that help your garage door function properly. The springs and cables of your garage door may wear out eventually, and broken ones may prevent the garage door from opening. As replacing a garage door spring can be a really dangerous task, you must consider asking for help from a professional garage door technician.

3. Check the opener mechanism of your garage door

If you feel that your garage door is not going down or working properly even after receiving power, it might have a mechanical failure.

• If you see that the door cannot function, but the engine sounds like it is running, then the main gear drive might have broken, and you need to replace it as soon as possible.
• If your garage door opener is a chain drive type, then you must ensure that the chain has the right tension, as too little tension may cause the chain to slip the sprocket and even fail to pull the trolley.

So, if you see that your garage door is not going down or not functioning properly, then you can try these ideas one by one. However, if you need to try these steps, you must consider contacting Vegas Garage Door Repair just by searching for garage door repair companies in my area, Las Vegas.